Pass4sure Cisco Certification

QUESTION 1:

Exhibit, excerpt from a “show run” display in a Cisco DSLAM.

You work as a network administrator at Certkiller .com. Referring to the output in the exhibit, what is true?

A. The CPE DSL modem is using ATM VPI 2, VCI 32. B. The CPE DSL modem is using ATM VPI 4, VCI 100.
C. The “dest-address” is the ATM NSAP address in the CPE DSL modem. D. The destination address can be reached via AM VPI 2, VCI 32.

Answer: A

QUESTION 2:

Network topology exhibit

You work as a network engineer at Certkiller .com. You troubleshoot a connectivity problem between Hosts Certkiller A and Certkiller B. The following conditions exist:
1. Host Certkiller A can ping the firewall, but cannot ping host Certkiller B
2. Host Certkiller B can both the firewall and www. Certkiller .com
3. The firewall can ping www. Certkiller .com
4. Host Certkiller C can ping the firewall and www. Certkiller .com
5. Host Certkiller A and Host Certkiller C have the same permissions on the firewall. What is the most likely problem?

A. Routing protocols in the network are not set up properly, and not propagating across the firewall.
B. Host Certkiller A has an incorrect default gateway configured. C. Host Certkiller B has an incorrect default gateway configured. D. Host Certkiller C has an incorrect default gateway configured. E. The firewall has an incorrect default gateway configured.

Answer: B

QUESTION 3:

Exhibit

You work as a network technician at Certkiller .com. A router has the above routes listed in
its routing table and receives a packet destined for 172.16.0.45. What will happen?

A. The router will not forward this packet, since it is destined for the 0 subnet.
B. The router will forward the packet through 172.31.116.65, since it has the lowest metric.
C. The router will forward the packet through 10.1.1.1.
D. The router will forward the packet through 172.31.116.65, since it has the lowest administrative distance.
E. The router will forward the packet through 192.168.1.4. Answer: C
QUESTION 4:

Exhibit, Cisco DSLAM configuration

Exhibit, Configuration of a Cisco 2600 router with an ADSL WIC installed.

You work as a network engineer at Certkiller .com. The CPE is connected to DSLAM DSL
port 1/1 via a DSL line. The subscriber’s DSL service is not working correctly. Based on the information shown in these two “show run” output messages, what is the subscriber’s trouble symptom?

A. The ADSL WIC will not train up to the DSLAM
B. The subscriber can access the internet, but the data throughput is slower than it should be.
C. The ADSL WIC will train up to the DSLAM, but the subscriber can not access the internet.

D. The subscriber can only access destination hosts on network 192.168.1.0

Answer: A

QUESTION 5:

You work as a network technician at Certkiller .com. A DSL modem will not train up. It is
on a “shared line” (DSL and POTS), and the telephone on the shared line is working normally. Nine of the conditions are possible causes of the symptom, and one is not. What is NOT a possible cause of the problem?

A. A defective DSL line card in the DSLAM B. A defective DSL CPE modem
C. An open (cut or broken) tip or ring lead on the phone line between the customer premises and the telco C.O
D. The DSL port in the DSLAM is in “shutdown” state.
E. The DSL port in the CPE DSL modem is in “shutdown” state.
F. The DSL operating mode in the DSLAM does not match the operating mode of the CPE DSL
modem.
G. A loose cable between the telco POTS splitter and DSLAM
H. A loose or broken connection between the DLS modem and the telephone line
I. An incorrectly connected POTS splitter between the DSL modem and the telephone line
J. A DSL microfilter was accidentally installed in the DSL line between the DSL modem and the
DSL line

Answer: C

QUESTION 6:

Your boss at Certkiller .com is curios about DSL. The following are distances used in telephone company cables.
Which will allow the greatest “reach” (distance) in DSL service?

A. 24 AWG (0.5 mm) B. 26 AWG (0.5 mm)
C. A line is 50% of #24 (0.5 mm) and 50% of #26 (0.4mm)
D. None of the above will allow enough reach for DSL service

Answer: A

QUESTION 7:

Network topology exhibit

Free 350-022 Exams’s PDF Download
Free Testking offers free demo for 350-022 PDF(CCIE Written, Service Provider: DSL). You can check out the interface, question quality and usability of our practice exams . We are the only one site can offer demo for almost all CCIE Written, Service Provider: DSL.

Recommended Training about 350-022 exam PDF
The following courses are the recommended training for 350-022 exam PDF.
350-022 Q & A with Explanations
350-022 Audio Exam
350-022 Study Guide
350-022 Preparation Lab

Exam Number/Code: 350-022
Exam Name: CCIE Written, Service Provider: DSL

“CCIE Written, Service Provider: DSL”, also known as 350-022 exam, is a Cisco certification.
Preparing for the 350-022 exam? Searching 350-022 Test Questions, 350-022 Practice Exam, 350-022 Dumps?

With the complete collection of questions and answers, Free Pass4sure has assembled to take you through 400 Q&As to your 350-022 Exam preparation. In the 350-022 exam resources, you will cover every field and category in CCIE helping to ready you for your successful Cisco Certification.

Questions and Answers : 400 Q&As
Updated: Sep 10th , 2008
Market Price: $159.99
Member Price: $99.99

Free download: pass4sure 350-022 CCIE
Free download:>testking 350-022 CCIE

PassGuide Braindumps: provides high quality Cisco exam practice questions and Training Materials.Hel you Pass Cisco Certifications

Download Free Latest Pass4sure P4S PassForsure Braindumps

1. Free Pass4sure 350-026 CCIE 2.95
2. Free Pass4sure 350-021 CCIE 2.95
3. Free Pass4sure 350-025 CCIE 2.83
4. Free Pass4sure 350-020 CCIE 2.73
5. Free pass4usre ccie 350-001 2.95
6. Free Pass4sure 350-029 CCIE 2.83
7. Free Pass4sure 350-001 CCIE 2.73
8. Free Pass4sure 350-023 CCIE 2.83
9. Free Pass4sure 350-030 CCIE 2.95
10. Free Pass4sure cisco ccie wireless 351-050