Pass4sure 350-040 CCIE 2.73
Question: 1
Which statements are true about a cascaded FICON topology? (Select three.)
A. It requires Fabric binding to be configured in all the switches. B. Only one hope (ie:traversing 2 switchs) is supported.
C. Separate ISLs must be used dedicated to FICON traffic.
D. Two byte link addressing as defined in FC-SB2, is mandatory.
Answer: A, B, D
Question: 2
MDS3 _ 9509# install all system bootflash:m9500-sf1 ek9-mz.1.3.4.bin kickstart bootflash:m9500-sfek9-kickstart-mz.1.3.4.bin
Verifying image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Verifying image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Extracting “sic”version from image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Extracting “ips” version from image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Extracting “system” version from image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Extracting “kickstart”version from image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Extracting “loader” version from image bootflash:/m9500-sf1ek9kickstart-mz.1.3.4.bin
[####################] 100% — SUCCESS
Compatibility check is done:
Module bootable impact install-type reason
——— ——— ———- ——- —– ———
2 yes non-disruptive rolling
3 yes disruptive rolling Hitless upgrade is not supported
5 yes non-disruptive reset
6 yes non-disruptive reset
Images will be upgraded according to following table:
Module Image Running-Version Net-Version Upg-Required
——— ——- ———- ————— ——————
2 slc 1.3(4b) 1.3(4) yes
2 bios v1.1.0 (10/24.03) v10.8(08/07/03) no
3 slc 1.3(4b) 1.3(4) yes
3 bios v1.1.0(10/24.03) v10.8(08/07/03) no
5 system 1.3(4b) 1.3(4) yes
5 kickstart 1.3(4b) 1.3(4) yes
5 bios v1.1.0(10/24.03) v10.8(08/07/03) no
5 loader 1.2(2) 1.2(2) no
6 system 1.3(4b) 1.3(4) yes
6 kickstart 1.3(4b) 1.3(4) yes
6 bios v1.1.0(10/24.03) v10.8(08/07/03) no
6 loader 1.2(2) 1.2(2) no
Do you want to continue with the installation (y/n)? [n]
TK
Exam Name: Storage Networking
Exam Type: Cisco
Exam Code: 350-040 Total Questions: 297
What is the reason the upgrade would not be hit-less for the entire switch, above?
A. The supervisor module requires a BIOS upgrade, which is disruptive.
B. The “rolling-upgrade” for module 2 requires a second “slc” to be hit-less.
C. Module 3 is an IPS-8 card, which does not support non-disruptive downgrades.
D. Nodule 3 is an IPS-8 and the switch does not have a second IPS-8 card for route diversity which could provide a “stable” upgrade.
E. No reason – the upgrade is non-disruptive and hit-less.
Answer: C Question: 3
Which methods can be used to control Iscsi INITIATOR ACCESS TO VIRTUAL TARGETS?
(Select three.)
A. Zoning
B. Specifying on which Gigabitethernet port the virtual target is advertised. C. Setting up Iscsi PROXY MODE FOR THE INITIATORS
D. Specifying which IP subnet virtual target can be accessed
E. Enabling role-based access control.
Answer: A, ?, ? Question: 4
In a scenario with three lSLs between two switches, a single host in VSAN 5 on switch A, and a single storage device on switch B in the same VSAN. What would be the effect on the lSLs if
Flow based load balancing option was enabled in VSAN 5?
A. Each subsequent frame will use the least utilized link, based on FCC. B. Each subsequent frame will use a different link.
C. All frames between source and destination would follow same link for given flow. D. Flow based load balancing is not enabled for an individual VSAN.
Answer: C
Flow based load balancing: all frames between source and destination would follow same link for given flow.
Question: 5
Which organization produce standards related to SCSI, Fiber Channel or Fiber Channel protocol? Select two.
A. SNIA
B. T11 Committee C. Cisco Systems D. T10 Committee
E. T12 Committee
Answer: B, D
=> T11 for fiber channel, T10 for SCSI
Question: 6
What is the User-specified VSAN Ids range?
TK
Exam Name: Storage Networking
Exam Type: Cisco
Exam Code: 350-040 Total Questions: 297
A. 1-4093
B. 2-4093
C. 2-4094
D. 2-4092
Answer: B
=> user-specific VSAN 2-4093
Question: 7
What can be configured on a FCIP Profile?
A. Max and Min bandwidth, peer-info, compression ratio
B. Passive mode, peer-info, compression ratio
C. TCP port number, sack-enable, Max and Min bandwidth
D. Sack-enable, TCP port number peer-info
E. TCP port number, write accelerator compression ratio
Answer: C
=> FCIP profile for TCP port, sack-enable, Max and Min bandwidth
Question: 8
A Brocade 12000 in its native corePID mode (1) is connected to VSAN 1009 on an MDS. What is the correct output of the “show vsan 1009” command?
A. vsan 1009 information:
Name: VSAN 1009 state:active
Interoperability mode:default loadbalancing:src-id/dst-id/oxid
Operational state:up. B. vsan 1009 information:
Name: VSAN 1009 state:active
Interoperability mode:1 loadbalancing:src-id/dst-id/oxid
Operational state:up. C. vsan 1009 information:
Name: VSAN 1009 state:active
Interoperability mode:2 loadbalancing:src-id/dst-id/oxid
Operational state:up. D. vsan 1009 information:
Name: VSAN 1009 state:active
Interoperability mode:3 loadbalancing:src-id/dst-id/oxid
Operational state:up.
E. vsan 1009 information: name: VSAN 1009 state:active
Interoperability mode:Brocade Native loadbalancing:src-id/dst-id/oxid
Operational state:up.
Answer: D
=> interop mode 3 for Brocade 12000
Question: 9
What TCP feature reduces the chances of oversized IP packets from being fragmented?
A. SACK
TK
Exam Name: Storage Networking
Exam Type: Cisco
Exam Code: 350-040 Total Questions: 297
B. Extended ping
C. PMTU
D. Retransmit timeout
E. Send buffer size
Answer: C Question: 10
In Raid 0+1 the loss of a single drive:
A. Does not affect the redundancy of the array
B. Reduces the array redundancy to that of a Raid level 0
C. Same level of redundancy to that of a Raid level 1+0
D. Reduces the performance of the array
E. Has no affect what so ever on the array
Answer: B Question: 11
Which are functions of the Domain identifier Assigned (DIA) ILS? Select two
A. It indicates that a Principal Switch has been selected, and that the upstream neighbor Switch has been assigned a Domain identifier.
B. It indicates that the receiving Switch can proceed requesting a Domain Identifier.
C. It indicates that the principal switch selection and address assignment phase is completed and the fabric is operational.
D. It indicates that the principal switch selection is started, but a principal switch has not been identified yet.
E. It indicates that a Request Domain Identifier ILS has been received by principal switch.
Answer: A, B Question: 12
What zoning option can be used in interop mode 2 and 3?
A. domain / port
B. nWWN C. fcid
D. lin zoning
E. sWWN
Answer: A Question: 13
You have a legacy JBOD that uses copper DB-9 connecters. You want to connect your JBOD to
a Fiber only Fiber Channel switch. You want to convert the DB-9 connection to multi mode Fiber
Optics. What device would you use?
A. HSSC B. MIA
C. GBIC D. SFP
E. DUAL SC
Answer: B
Free 350-040 Exams’s PDF Download
Free Testking offers free demo for 350-040 PDF(CCIE Storage Networking). You can check out the interface, question quality and usability of our practice exams . We are the only one site can offer demo for almost all CCIE Storage Networking.
Recommended Training about 350-040 exam PDF
The following courses are the recommended training for 350-040 exam PDF.
350-040 Q & A with Explanations
350-040 Audio Exam
350-040 Study Guide
350-040 Preparation Lab
Exam Number/Code: 350-040
Exam Name: CCIE Storage Networking
VUE Code: 350-040
Questions Type: Single choice,
Question Numbers of Real-exam: 100 questions
“CCIE Storage Networking”, also known as 350-040 exam, is a Cisco certification.
Preparing for the 350-040 exam? Searching 350-040 Test Questions, 350-040 Practice Exam, 350-040 Dumps?
With the complete collection of questions and answers, Pass4sure has assembled to take you through 397 Q&As to your 350-040 Exam preparation. In the 350-040 exam resources, you will cover every field and category in CCIE helping to ready you for your successful Cisco Certification.
Questions and Answers : 397 Q&As
Updated: Sep 5th , 2008
Market Price: $159.99
Member Price: $99.99
Pass4sure 350-040 CCIE
Interactive Testing Engine Included!
261 Questions
Updated : 09/18/2008
Price : $131.99 $119.99
Download Free Latest Pass4sure P4S PassForsure Braindumps
- Free Pass4sure 350-025 CCIE 2.83
- Free Pass4sure 350-001 CCIE 2.73
- Free Pass4sure 642-356 CSSSS 2.93
- Free Pass4sure 350-022 CCIE 2.83
- Free Pass4sure 350-029 CCIE 2.83
- Free Pass4sure 646-011 CSSS 2.83
- Free Pass4sure 350-018 CCIE 2.93
- Free Pass4sure 350-020 CCIE 2.73
- Free Pass4sure 350-024 CCIE 2.83
- Free Pass4sure 350-023 CCIE 2.83
Recent Comments