Pass4sure Cisco Certification

QUESTION 1:
Which statements are true regarding ATM-Ethernet PW Interworking? Select two. A. IP Interworking is supported.
B. Ethernet Interworking is supported.
C. LLC Interworking is supported.
D. ATM-Ethernet Interworking is not possible. Answer: A, B
Explanation: See Table 1 at:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1838/products_feature_guide09186a008029b264.html

QUESTION 2:

To eliminate the need for adjacent routers on broadcast networks to form n(n-1)/2 adjacencies, IS-IS
defines a pseudonode or Designated intermediate System, DIS. All router on the broadcast medium form
an adjacency with the DIS. The Backup DIS is called:

A. Redundant DIS B. BDR
C. There is no concept of a backup DIS in IS-IS D. Designated Redundant System
Answer: C Explanation:
1) http://www.cisco.com/warp/public/97/DIS-LSP-1.html
“On broadcast multi-access networks, a single router is elected as the DIS. There is no backup DIS elected. The
DIS is the router that creates the pseudonode and acts on behalf of the pseudonode.”
2) http://www.cisco.com/warp/public/97/is-is-ip-config.html
“Notice that the DIS is elected for both levels, and that no backup DIS exists, as with Open Shortest Path First
(OSPF), which has a backup Designated Router (DR).”
3) http://www.ciscopress.com/articles/article.asp?p=31319&rl=1
“No backup DIS exists in IS-IS, in contrast to the backup DR for OSPF. If a DIS dies, a new election takes place”

QUESTION 3:
What ISDN timer is started after Q.931 SETUP msg is sent? A. T301
B. T303

C. T302
D. T310
E. T305
Answer: D Explanation:
If the Call Setup message is not acknowledged before the T303 timer expires, the CPE sends a second Call Setup message and restart T303. If T303 expires a second time, the call is cleared and disconnected.
Incorrect Answers:
T301 timer is for “Call Proceeding” not SETUP.

QUESTION 4:
Which statements are true regarding Interworking? Select two. A. Interworking is only supported in AToM.
B. Interworking is supported in AToM and L2TPv3.
C. Ethernet Interworking is only supported if one AC is Ethernet or VLAN. D. FR-PPP is not supported.
Answer: B, C Explanation:
Table1 L2VPN Interworking Supported Features
Feature MPLS or L2TPv3 Support IP or Ethernet Support
Frame Relay to Ethernet/VLAN MPLS L2TPv3
IP Ethernet
Frame Relay to PPP MPLS L2TPv3
IP
Frame Relay to ATM AAL5 MPLS IP Ethernet/VLAN to ATM AAL5 MPLS IP Ethernet
Ethernet to VLAN MPLS L2TPv3
IP Ethernet
http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1838/products_feature_guide09186a008029b264. html#wp107
Item “C” just means that to support Ethernet one end or the other of the Attachment Circuit has to
be Ethernet. Note that in the third column where “Ethernet” appears, one or the other (or both) in column 1 is “Ethernet” (or VLAN).

Look for any Transport over MPLS for information on configuring AToM.
For configuring L2VPN Interworking, see L2VPN Interworking.

QUESTION 5:

Observering the output below from the CK router, select what path EoMPLS will take before exiting a router:
CK#show mpls 12transport vc 100 detail
Local interface: Fa0/0.1 up, line protocol up, Eth VLAN 100 up Destination address: 172.0.0.3, VC ID: 100, VC status: up Preferred path: Tunnel1, active
Default path: disabled
Tunnel label: 3, next hop point2point
Output interface: Tu1, imposed label stack {27 20} Create time: 00:07:11, last status change time: 00:07:11
Signaling protocol: LDP 16, remote 20
MPLS VC labels: local 16, remote 20
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled

A. 172.0.0.3
B. FastEthernet 0/0
C. FastEthernet 0/0.1
D. Tunnel1
E. This is an invalid output

Answer: D

QUESTION 6:

What is NOT true regarding PW QoS?

A. A policy action can be applied for packets matched by DLCI.
B. LLQ can be applied to traffic classified per COS on Ethernet AC.
C. CB-WFQ can be applied to traffic classified per COS on Ethernet AC. D. The command ’set cos’ is used to modify the .1p cos bits in a policy.
E. The command ’set vlan’ is used to modify the VLAN tag in a policy. F. All of the above.

Answer: E

QUESTION 7:

According to the IEEE 802.3 CSMA/CD specification, what is the proper signal for contact 6 of a PHY

Free 350-027 Exams’s PDF Download
Free Testking offers free demo for 350-027 PDF(CCIE Written: Metro Ethernet). You can check out the interface, question quality and usability of our practice exams . We are the only one site can offer demo for almost all CCIE Written: Metro Ethernet.

Recommended Training about 350-027 exam PDF
The following courses are the recommended training for 350-027 exam PDF.
350-027 Q & A with Explanations
350-027 Audio Exam
350-027 Study Guide
350-027 Preparation Lab

Exam Number/Code: 350-027
Exam Name: CCIE Written: Metro Ethernet

“CCIE Written: Metro Ethernet”, also known as 350-027 exam, is a Cisco certification.
Preparing for the 350-027 exam? Searching 350-027 Test Questions, 350-027 Practice Exam, 350-027 Dumps?

With the complete collection of questions and answers, Free Pass4sure has assembled to take you through 400 Q&As to your 350-027 Exam preparation. In the 350-027 exam resources, you will cover every field and category in CCIE helping to ready you for your successful Cisco Certification.

Questions and Answers : 400 Q&As
Updated: Sep 7th , 2008
Market Price: $159.99
Member Price: $99.99

PassGuide Braindumps: provides high quality Cisco exam practice questions and Training Materials.Hel you Pass Cisco Certifications

Download Free Latest Pass4sure P4S PassForsure Braindumps

1. Free Pass4sure 350-029 CCIE 2.83
2. Free Pass4sure 350-023 CCIE 2.83
3. Free Pass4sure 350-026 CCIE 2.95
4. Free Pass4sure 350-018 CCIE 2.93
5. Free Pass4sure 350-020 CCIE 2.73
6. Free Pass4sure 350-001 CCIE 2.73
7. Free Pass4sure 350-021 CCIE 2.95
8. Free Pass4sure 350-040 CCIE 2.73
9. Free Pass4sure 350-025 CCIE 2.83
10. Free Pass4sure 350-022 CCIE 2.83